Timer - Dell Z9500 Reference Manual

•
Example
Dell#show frrp summary
(Summary)
Ring-ID State Mode
----------------------------------------------
2
31
50
Dell#
Example (1)
Dell#show frrp 1
Ring protocol 1 is in Master mode
Ring Protocol Interface:
Primary : TenGigabitEthernet 0/16 State: Forwarding
Secondary: Port-channel 100 State: Blocking
Control Vlan: 1
Ring protocol Timers: Hello-Interval 50 msec Dead-Interval 150
msec
Ring Master's MAC Address is 00:01:e8:13:a3:19
Topology Change Statistics: Tx:110 Rx:45
Hello Statistics: Tx:13028 Rx:12348
Number of state Changes: 34
Member Vlans: 1000-1009
Dell#
Example (2
Dell#show frrp 2 summary
Summary)
Dell#show frrp 2 summary
Ring-ID State Mode
-----------------------------------------------
2
Dell#
Related protocol frrp
Commands

timer

Set the hello interval or dead interval for the Ring control packets.
Z9500
Syntax
timer {hello-interval milliseconds}| {dead-interval
milliseconds}
To remove the timer, use the no timer {hello-interval
[milliseconds]}| {dead-interval milliseconds} command.
Parameters
hello-interval
milliseconds
Force10 Resilient Ring Protocol (FRRP)
The number of state change counters
Ctrl_Vlan Member_Vlans
UP Master
UP Transit
Down Transit
Ctrl_Vlan Member_Vlans
Up Master 2
— enters the resilient ring protocol and designate a ring identification.
Enter the keyword hello-interval then the time, in
milliseconds, to set the hello interval of the control packets.
The milliseconds must be entered in increments of 50
millisecond; for example, 50, 100, 150, and so on. If an
2 11-20, 25,27-30
31 40-41
50 32
11-20, 25, 27-30
761