Deny Udp (For Ipv6 Acls) - Dell Z9500 Reference Manual

Hide thumbs Also See for Z9500:

Table of Contents

Layer 3 ingress and egress traffic. You may specify traffic using standard or

extended access-lists. This mechanism copies all incoming or outgoing packets on

one port and forwards (mirrors) them to another port. The source port is the

monitored port (MD) and the destination port is the monitoring port (MG).

deny udp (for IPv6 ACLs)

Configure a filter to drop user datagram protocol (UDP) packets meeting the filter criteria.

deny udp {source address mask | any | host ipv6-address}

[operator port [port]] {destination address | any | host ipv6-

address} [operator port [port]] [count [byte]] [log [interval

minutes] [threshold-in-msgs [count]] [monitor]

To remove this filter, you have two choices:

threshold-in

By default, 10 ACL logs are generated if you do not specify the threshold explicitly.

The default frequency at which ACL logs are generated is five minutes. By default,

flow-based monitoring is not enabled.

Version 9.5(0.1)

Use the no seq sequence-number command syntax if you know the filter's

sequence number

Use the no deny udp {source address mask | any | host ipv6-

address} {destination address | any | host ipv6-address}

(OPTIONAL) Enter the keyword log to enable the triggering

of ACL log messages.

(OPTIONAL) Enter the threshold-in-msgs keyword

followed by a value to indicate the maximum number of ACL

logs that can be generated, exceeding which the generation

of ACL logs is terminated. with the seq, permit, or deny

commands. The threshold range is from 1 to 100.

(OPTIONAL) Enter the keyword interval followed by the

time period in minutes at which ACL logs must be generated.

The threshold range is from 1 to 10 minutes.

(OPTIONAL) Enter the keyword monitor when the rule is

describing the traffic that you want to monitor and the ACL

in which you are creating the rule is applied to the monitored

Introduced on the Z9500.

IPv6 Access Control Lists (IPv6 ACLs)