Match Route-Type - Dell Z9500 Reference Manual

igp
incomplete
Defaults Not configured.
Command ROUTE-MAP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking TOS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
6.1.1.0

match route-type

To match routes based on the how the route is defined, configure a filter.
Z9500
Syntax
match route-type {external [type-1 | type-2] | internal |
level-1 | level-2 | local}
To delete a match, use the no match route-type {local | internal |
external [type-1 | type-2] | level-1 | level-2} command.
Parameters
external
[type-1| type-2]
internal
level-1
level-2
local
Access Control Lists (ACL)
Enter the keyword igp to match routes originating within
the same AS.
Enter the keyword incomplete to match routes with
incomplete routing information.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the E-Series.
Enter the keyword external then either type-1 or type-2 to
match only on OSPF Type 1 routes or OSPF Type 2 routes.
Enter the keyword internal to match only on routes
generated within OSPF areas.
Enter the keyword level-1 to match IS-IS Level 1 routes.
Enter the keyword level-2 to match IS-IS Level 2 routes.
Enter the keyword local to match only on routes generated
within the switch.
301