Ipv6 Neighbor - Dell Z9500 Reference Manual

ipv6 neighbor

Configure a static entry in the IPv6 neighbor discovery.
Z9500
Syntax
ipv6 neighbor {ipv6-address} {interface interface}
{hardware_address}
To remove a static IPv6 entry from the IPv6 neighbor discovery, use the no ipv6
neighbor {ipv6-address} {interface interface} command.
Parameters
ipv6-address
interface
interface
hardware_addr
ess
Defaults none
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.1
Usage Neighbor Discovery Protocol for IPv6 is defined in RFC 2461 as part of the Stateless
Information Address Autoconfiguration protocol. It replaces the Address Resolution Protocol
used with IPv4. It defines mechanisms for solving problems, such as:
992
Enter the IPv6 address of the neighbor in the x:x:x:x::x
format.
NOTE: The :: notation specifies successive hexadecimal
fields of zero.
Enter the keyword interface then the interface type and
slot/port or number information:
• For a Port Channel interface, enter the keywords port-
channel then a number.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Enter a 48-bit hardware MAC address in nn:nn:nn:nn:nn:nn
format.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
IPv6 Basics