Dell Z9500 Reference Manual page 952

Version
7.6.1.0
7.5.1.0
6.1.1.0
Usage The following describes the show ip traffic summary shown in the following
Information
example.
Keyword
unknown
protocol...
not a gateway...
security failures...
bad options...
Frags:
... reassembled
... timeouts
... too big
... couldn't
fragment
...encapsulation
failed
Rcvd:
...short packets
...bad length
...no port
broadcasts
...socket full
The F10 Monitoring MIB provides access to the following statistics.
952
Description
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Definition
No receiver for these packets. Counts packets whose
protocol type field is not recognized by the system.
Packets can not be routed; the host/network is unreachable.
Counts the number of received unicast/multicast packets
that could not be forwarded due to:
• route not found for unicast/multicast; ingress interfaces
do not belong to the destination multicast group
• destination IP address belongs to reserved prefixes; the
host/network is unreachable
Unrecognized IP option on a received packet.
IP fragments received.
Number of IP fragments that were reassembled.
Number of times a timer expired on a reassembled queue.
Number of invalid IP fragments received.
Number of packets that could not be fragmented and
forwarded.
Counts packets which could not be forwarded due to ARP
resolution failure. The system sends an ARP request prior to
forwarding an IP packet. If a reply is not received, the system
repeats the request three times. These packets are counted
in encapsulation failed.
Total number of packets received from specified protocol.
The number of bytes in the packet are too small.
The length of the packet was not correct.
The incoming broadcast/multicast packet did not have any
listener.
The applications buffer is full and the incoming packet are
dropped.
IPv4 Routing