Group - Dell Z9500 Reference Manual

shutdown

group

Group two LAGs in a supergroup ("fate-sharing group" or "failover group").
Z9500
Syntax
group group_number port-channel number port-channel number
To remove an existing LAG supergroup, use the no group group_number
command.
Parameters
group_number
port-channel
number
Defaults none
Command PORT-CHANNEL FAILOVER-GROUP (conf-po-failover-grp)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
Related
port-channel failover-group
Commands
mode to configure a LAG failover group.
show interfaces port-channel
groups.
862
— disables/enables the port channel.
Enter an integer from 1 to 32 that uniquely identifies this LAG
fate-sharing group.
Enter the keywords port-channel then an existing LAG
number. Enter this keyword/variable combination twice,
identifying the two paired LAGs.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the C-Series, E-Series, and S-Series.
— accesses PORT-CHANNEL FAILOVER-GROUP
— displays information on configured Port Channel
Interfaces