Dell Z9500 Reference Manual page 804

Hide thumbs Also See for Z9500:

Table of Contents

vrrp [[ipv6] vrid]

learning-limit

vlan vlan-id

Without an interface specified, the command clears all interface counters.

EXEC Privilege

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

For a tunnel interface, enter the keyword tunnel. The

range is from 1 to 16383.

(OPTIONAL) Enter the keyword vrrp to clear the counters of

all VRRP groups. To clear the counters of VRRP groups on all

IPv6 interfaces, enter ipv6. To clear the counters of a

specified group, enter a VRID number from 1 to 255.

(OPTIONAL) Enter the keywords learning-limit to clear

unknown source address (SA) drop counters when MAC

learning limit is configured on the interface.

Enter the keyword vlan followed by the interface VLAN

number. The range is from 1 to 4094.

Introduced on the S6000-ON.

Added the vlan parameter.

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the Z9000.

Added support for 4-port 40G line cards on ExaScale.

Added support (E-Series only) for VRRP groups in a VRF

Introduced on the S4810.

Added support for 4093 VLANs on the E-Series ExaScale.

Prior to the release, 2094 was supported.

Introduced on the E-Series ExaScale.

Introduced on the S-Series.

Introduced on the C-Series.

Updated the definition of the learning-limit option for