Test Cam-Usage - Dell Z9500 Reference Manual

Hide thumbs Also See for Z9500:

Table of Contents

nlbclusteracl:

-- linecard 2 --

nlbclusteracl:

test cam-usage

Verify the CAM space that is available for IPv4 and IPv6 CAM profiles, and particularly to verify if enough

CAM space is available for the IPv6 ACLs you use in a policy map.

test cam-usage service-policy input policy-map-name linecard

{number portset {port-pipe-number} | all}

input policy-

number portset

EXEC Privilege

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Content Addressable Memory (CAM)

Current Settings(in block sizes)

1 block = 256 entries

Enter the name of the policy map to verify. Maximum is 32

Enter a line card and port-pipe number to check CAM usage

on specified ports. The range of valid port-pipe numbers is 0

to 3. Enter linecard all to verify the CAM space available

for all ports on the switch.