Dell Z9500 Reference Manual page 268

Defaults Not enabled.
Command CONFIGURATION-MAC ACCESS LIST-STANDARD
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
7.5.1.0
7.4.1.0
Usage
When you use the log option, the CP processor logs detail the packets that match.
Information
Depending on how many packets match the log entry and at what rate, the CP
may become busy as it has to log these packet details.
Use the monitor option only when you are using flow-based monitoring. For
more information, refer to the Port Monitoring chapter in the Z9500 Configuration
Guide.
By default, 10 ACL logs are generated if you do not specify the threshold explicitly.
The default frequency at which ACL logs are generated is five minutes. By default,
flow-based monitoring is not enabled.
Related
permit
Commands
seq
268
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Added the monitor option.
NOTE: When ACL logging and byte counters are configured simultaneously,
byte counters may display an incorrect value. Configure packet counters with
logging instead.
— configures a MAC address filter to pass packets.
— configures a MAC address filter with a specified sequence number.
Access Control Lists (ACL)