Show Ip Protocol-Queue-Mapping - Dell Z9500 Reference Manual

Q22
Q23
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.8.0

show ip protocol-queue-mapping

Display the Z9500 CPU queue mapping for IPv4 protocols.
Z9500
Syntax
show ip protocol-queue-mapping
Defaults Not configured.
Command EXEC Privilege
Modes
Usage
The show output displays information on CPU traffic flows for IPv4 protocols,
Information
including the ingress queue at which the traffic is queued and the CPU to which
protocol traffic is sent with the applied rate limits (configured or default) in kilobits
per second (kbps). The egress port queues on CPUs are abbreviated as: RP (Route
Processor), CP (Control Processor), and LC (line card).
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.8.0
Control Plane Policing (CoPP)
800
5000
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
1000
5000
571