Show Ip Bgp Peer-Group - Dell Z9500 Reference Manual

Version
8.3.11.1
8.3.7.0
7.8.1.0
7.7.1.0
Usage
The following describes the show ip bgp paths community command shown
Information
in the following example.
Field
Address
Hash
Refcount
Community
Example
Dell#show ip bgp paths community
Total 2 communities
Refcount
1
1

show ip bgp peer-group

Allows you to view information on the BGP peers in a peer group.
Z9500
Syntax
show ip bgp [vrf vrf-name] [ipv4 {multicast | unicast} | ipv6
unicast] peer-group [peer-group-name [detail | summary]]
Parameters
vrf vrf-name
ipv4 multicast
ipv4 unicast
452
Description
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Description
Displays the internal address where the path attribute is
stored.
Displays the hash bucket where the path attribute is stored.
Displays the number of BGP routes using these
communities.
Displays the community attributes in this BGP path.
Community
NO-ADVERTISE
200:1 1000:1
(OPTIONAL) Enter the keyword vrf to view information on
BGP peers in a peer group corresponding to that VRF.
NOTE: You can use this attribute to view information on
BGP peers in a peer group that correspond to either a
default or a non-default VRF.
(OPTIONAL) Enter the keyword ipv4 followed by the
keyword multicast to view information related only to ipv4
multicast routes.
(OPTIONAL) Enter the keyword ipv4 followed by the
keyword unicast to view information related only to ipv4
unicast routes.
3000:1
Border Gateway Protocol