Hardware Commands; Clear Control-Traffic - Dell Z9500 Reference Manual

If the default buffer-profile is active, Dell Networking OS displays an error message
instructing you to remove the default configuration using the no buffer-
profile global command.
Reload the system for the global buffer-profile to take effect.

Hardware Commands

The hardware commands supported on the switch allow you to display information from a hardware
sub-component or ASIC.

clear control-traffic

Clear control-traffic statistics from a Z9500 CPU.
Z9500
Syntax
clear control—traffic {all | cp—switch | linecard slot-id
portset port-pipe} counters
Parameters
cp-switch
linecard slot-id
portset port-
pipe
all
Defaults None.
Command EXEC Privilege
Modes
Example
Dell# clear control-traffic cp-switch counters
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.11.1
640
Enter the keyword cp-switch to clear the counters for
control traffic on the control plane.
Enter the slot ID and port pipe to clear the counters for
control traffic on a specified Z9500 line card and port set.
The range of Z9500 slot IDs is from 0 to 2. The range of
port-pipe numbers is: 0 to 2 on line card 0 and 0 to 3 on line
cards 1 and 2.
Enter the keyword all to clear control-traffic statistics on
the control plane and all line cards.
Description
Introduced on the Z9500.
Introduced on the Z9000.
Debugging and Diagnostics