Ipv6 Flowlabel-Zero - Dell Z9500 Reference Manual

To restore the default value, use the no ipv6 control-plane icmp error-
rate-limit command.
Parameters
pps
Default 100 pps
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0

ipv6 flowlabel-zero

Configure system to set the flow label field in the packets to zero.
Z9500
Syntax
ipv6 flowlabel-zero
To disable the 0 from being set in the field and allow the rotocol operations to fill
the field, use the no ipv6 flowlabel-zero command.
Default Disabled
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
986
Enter the maximum number of error packets generated per
second. The range is from 1 to 200, where 0 disables the
rate-limiting.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
IPv6 Basics