Dell Z9500 Reference Manual page 171

Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.0.2.0
9.0.0.0
8.3.19.0
8.3.12.0
8.3.11.1
8.2.1.0
8.1.1.0
7.6.1.0
7.5.1.0
Usage
The VRF configured using this command has a higher precedence than a VRF
Information
configured using the ip telent vrf vrf-name command. If you do not use the
VRF attribute in this command, then TELENT client uses the VRF configured using
the ip telnet vrf vrf-name command.
The source interface configured using this command has a higher precedence than
the source interface configured using the ip telent source-interface
command. If you do not configure a source interface using this command, then
the TELNET client uses the source interface configured using the ip telent
source-interface command.
In case there is a mismatch between the VRF telnet source interface and the telent
VRF, then an error is reported.
Example
Dell#telnet vrf vrf1 10.10.10.2
Control and Monitoring
Description
Introduced on the S6000-ON.
Introduced on the S6000.
Introduced on the Z9000.
Introduced on the S4820T.
Introduced on the S4810. Added support for source-
interface for link-local IPv6 addressing.
Introduced on the Z9000.
Introduced on the E-Series ExaScale (IPv6). Increased the
number of VLANs on ExaScale to 4094 (was 2094).
Introduced on the E-Series ExaScale (IPv4).
Introduced on the S-Series.
Introduced on the C-Series and added support for IPv6
address on the E-Series only.
171