Port-Channel Failover-Group - Dell Z9500 Reference Manual

Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
7.5.1.0
6.2.1.0
Usage
If you use this command to configure the minimum number of links in a LAG that
Information
must be in "oper up" status, the LAG must have at least that number of "oper up"
links before it can be declared as up. For example, if the required minimum is four,
and only three are up, the LAG is considered down.

port-channel failover-group

To configure a LAG failover group, access PORT-CHANNEL FAILOVER-GROUP mode.
Z9500
Syntax
port-channel failover-group
To remove all LAG failover groups, use the no port-channel failover-group
command.
Defaults none
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
Interfaces
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
865