Neighbor Bfd - Dell Z9500 Reference Manual

Defaults See Parameters
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
9.2.0.0
Usage
This command provides the flexibility to fine-tune the timer values based on
Information
individual interface needs when you configure ipv6 ospf BFD in CONFIGURATION
mode. Any timer values specified with this command overrides timers set using the
bfd all-neighbors command. Using the no form of this command does not
disable BFD if you configure BFD in CONFIGURATION mode.
To disable BFD on a specific interface while you configure BFD in
CONFIGURATION mode, use the keyword disable.

neighbor bfd

Explicitly enable a BFD session with a BGP neighbor or a BGP peer group.
Z9500
Syntax
neighbor {ip-address | peer-group-name} bfd
Parameters
ip-address
peer-group-
name
Defaults none
Command ROUTER BGP
Modes
Bidirectional Forwarding Detection (BFD)
The default is Active.
Description
Introduced on the Z9500.
Introduced on the Z9000, S4820T, and S4810.
Enter the IP address of the BGP neighbor that you want to
explicitly enable for BFD sessions in dotted decimal format
(A.B.C.D).
Enter the name of the peer group that you want to explicitly
enable for BFD sessions.
331