Show Cpu-Interface-Stats - Dell Z9500 Reference Manual

Version
6.2.1.1
Usage Traffic statistics are sorted on a per-interface basis; the interface receiving the most
Information traffic is displayed first. All CPU and port information is displayed unless a specific
port or CPU is specified. Traffic information is displayed for router ports only; not
for management interfaces. The traffic statistics are collected only after the debug
cpu-traffic-stats command is executed; not from the system bootup.
Example
Dell#show cpu-traffic-stats
Processor : CP
--------------
Processor : RP
---------------
Related debug cpu-traffic-stats
Commands

show cpu-interface-stats

View CPU interface statistics.
Z9500
Syntax
show cpu-interface-stats [cp | rp | linecard {0–2} |all]
Parameters
cp
rp
linecard slot-id
all
Control and Monitoring
Description
Introduced on the E-Series.
NOTE: After debugging is complete, use the no debug cpu-traffic-
stats command to shut off traffic statistics collection.
Received 100% traffic on fortyGigE 2/12
LLC:0, SNAP:0, IP:5, ARP:0, other:3
Unicast:5, Multicast:3, Broadcast:0
Received 100% traffic on fortyGigE 2/12
LLC:0, SNAP:0, IP:165, ARP:0, other:3
Unicast:42, Multicast:126, Broadcast:0
— enables CPU traffic statistics for debugging.
Enter the keyword cp to display the interface statistics only
from the Control Processor.
Enter the keyword rp to display the interface statistics only
from the Route Processor.
Enter the linecard slot-id parameters to display the
interface statistics only from a specified line card. The range
of line-card slot IDs is from 0 to 2.
Enter the keyword all to display the interface statistics from
all Z9500 CPUs, including the Control Processor, Route
Processor, and line cards.
Total packets:8
Total packets:168
133