Dell Z9500 Reference Manual page 188

Hide thumbs Also See for Z9500:

Table of Contents

Not configured.

CONFIGURATION (conf-if-interface-slot/port)

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

802.1X authentication is enabled when an interface is connected to the switch. If

the host fails to respond within a designated amount of time, the authenticator

places the port in the guest VLAN.

If a device does not respond within 30 seconds, it is assumed that the device is not

802.1X capable. Therefore, a guest VLAN is allocated to the interface and

authentication, for the device, occurs at the next reauthentication interval (dot1x

reauthentication).

If the host fails authentication for the designated number of times, the

authenticator places the port in authentication failed VLAN (dot1x auth-fail-

Enter the VLAN Identifier. The range is from 1 to 4094.

Introduced on the Z9500.

Introduced on the S4820T.

Introduced on the S4810.

Introduced on the Z9000.

Introduced on the C-Series, E-Series, and S-Series.

NOTE: You can create the Layer 3 portion of a guest VLAN and authentication

fail VLANs regardless if the VLAN is assigned to an interface or not. After an

interface is assigned a guest VLAN (which has an IP address), routing through

the guest VLAN is the same as any other traffic. However, the interface may

join/leave a VLAN dynamically.

dot1x auth-fail-vlan

dot1x reauthentication

dot1x reauth-max

show dot1x interface