Show Ip Bgp Dampened-Paths - Dell Z9500 Reference Manual

Hide thumbs Also See for Z9500:

Table of Contents

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

The higher the administrative distance assigned to a route means that your

confidence in that route is low. Routes assigned an administrative distance of 255

are not installed in the routing table. Routes from confederations are treated as

internal BGP routes.

show ip bgp dampened-paths

View BGP routes that are dampened (non-active).

show ip bgp [vrf vrf-name] [ipv4 {multicast | unicast} | ipv6

unicast] dampened-paths

vrf vrf-name

ipv4 unicast

Border Gateway Protocol

external-distance = 20

internal-distance = 200

local-distance = 200

Introduced on the Z9500.

Introduced on the S4820T.

Introduced on the S4810.

Introduced on the S-Series.

Introduced on the C-Series.

CAUTION: Dell Networking recommends not changing the administrative

distance of internal routes. Changing the administrative distances may cause

routing table inconsistencies.

— enters ROUTER mode on the switch.

(OPTIONAL) Enter the keywords vrf and then the name of

the VRF to view routes that are affected by a specific

community list corresponding to that VRF.

(OPTIONAL) Enter the keywords ipv4 followed by the

keyword unicast to view information related only to ipv4

unicast routes.