Dell Z9500 Reference Manual page 790

Hide thumbs Also See for Z9500:

Table of Contents

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

E-Series legacy

IGMP commands accept only non-VLAN interfaces — specifying VLAN does not

yield results.

The show ip igmp interface command does not display information

corresponding to the loop-back interfaces.

Dell#show ip igmp interface

TenGigabitEthernet 1/1 is down, line protocol is down

TenGigabitEthernet 1/5 is down, line protocol is down

TenGigabitEthernet 1/6 is down, line protocol is down

TenGigabitEthernet 1/7 is up, line protocol is down

For a port channel interface, enter the keywords port-

channel then a number.

For a VLAN interface, enter the keyword vlan then a

number from 1 to 4094.

EXEC Privilege

Added support for VRF. Introduced on the S6000-ON.

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

Introduced on the S-Series.

Introduced on the C-Series.

Internet protocol processing disabled

Inbound IGMP access group is not set

Internet address is 35.0.0.1/24

IGMP is enabled on interface

IGMP query interval is 60 seconds

IGMP querier timeout is 125 seconds

IGMP max query response time is 10 seconds

IGMP last member query response interval is 1000 ms

IGMP immediate-leave is enabled for all groups

IGMP activity: 0 joins

Internet Group Management Protocol (IGMP)