Duplex (Management) - Dell Z9500 Reference Manual

Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
7.5.1.0
7.4.1.0
Usage
Important Points to Remember:
Information
•
•
•
•
•
Related show interfaces
Commands

duplex (Management)

Set the mode of the Management interface.
Z9500
Syntax
duplex {half | full}
To return to the default setting, use the no duplex command.
Parameters
half
808
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Modified for E-Series: Revised from 78 to 240 characters.
To use special characters as a part of the description string, you must enclose
the whole string in double quotes.
Spaces between characters are not preserved after entering this command
unless you enclose the entire description in quotation marks ("desc_text").
Entering a text string after the description command overwrites any previous
text string that you previously configured as the description.
The shutdown and description commands are the only commands that you
can configure on an interface that is a member of a port-channel.
Use the show interfaces description command to display descriptions
configured for each interface.
— displays information about an interface.
Enter the keyword half to set the Management interface to
transmit only in one direction.
Interfaces