Ip Igmp Version - Dell Z9500 Reference Manual

Version
7.5.1.0
E-Series legacy
command
Usage
A group in include mode must have at least one source address defined. In
Information
exclude mode, if you do not specify a source address, Dell Networking OS
implicitly assumes all sources are included. If you do not specify either include or
exclude, Dell Networking OS implicitly assumes a IGMPv2 static join.
Command Limitations
•
•
Related show ip igmp groups
Commands

ip igmp version

Manually set the version of the router to IGMPv2 or IGMPv3.
Z9500
Syntax
ip igmp version {2 | 3}
Parameters
2
3
Defaults 2 (that is, IGMPv2)
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
786
Description
Expanded to support the exclude and include options.
Only one mode (include or exclude) is permitted per multicast group per
interface. To configure another mode, all sources belonging to the original
mode must be unconfigured.
If a static configuration is present and a packet for the same group arrives on an
interface, the dynamic entry completely overwrites all the static configuration
for the group.
— displays IGMP group information.
Enter the number 2 to set the IGMP version number to
IGMPv2.
Enter the number 3 to set the IGMP version number to
IGMPv3.
Description
Changed the default IGMP from version 2 to version 3.
Introduced on the S6000-ON
Internet Group Management Protocol (IGMP)