Neighbor Password - Dell Z9500 Reference Manual

Defaults Disabled.
Command ROUTER BGPV6-ADDRESS FAMILY
Modes
Command
Version
History
9.2(1.0)
8.2.1.0
7.4.1.0
Usage If you configure the set ipv6 next-hop command in ROUTE-MAP mode, its
Information configuration takes precedence over the neighbor next-hop-self command.

neighbor password

Enable message digest 5 (MD5) authentication on the TCP connection between two neighbors.
Z9500
Syntax
neighbor {ip-address | peer-group-name} password [encryption-
type] password
To delete a password, use the no neighbor {ip-address | peer-group-
name} password command.
Parameters
ip-address
peer-group-
name
encryption-
type
password
Defaults Not configured.
Command ROUTER BGP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
398
Description
Introduced on the Z9500.
Introduced on the E-Series ExaScale.
Introduced
Enter the IP address of the router to be included in the peer
group.
Enter the name of a configured peer group.
(OPTIONAL) Enter 7 as the encryption type for the password
entered. 7 means that the password is encrypted and hidden.
Enter a text string up to 80 characters long. The first
character of the password must be a letter.
You cannot use spaces in the password.
Border Gateway Protocol