Util-Threshold Memory - Dell Z9500 Reference Manual

Defaults
•
•
Command CONFIGURATION
Modes
Command
Version
History
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
Example
Dell(conf)# util-threshold cpu 5sec cp high 50
In this example, the low threshold value is not specified so it will take the value set
for the high threshold value. In all other cases, the low threshold value must be
equal to or less than that of the high threshold value.
Usage When the total CPU utilization exceeds the configured threshold for the specified
Information time, a threshold notification is sent as an SNMP trap. If a low threshold value is not
specified, the low threshold value is set to the same value as the high threshold
value. The system will generate a Syslog and SNMP trap each time the configured
CPU threshold is crossed.
Related
•
Commands
•

util-threshold memory

Configure the high or low memory utilization thresholds for SNMP traps.
Z9500
Syntax
util—threshold memory {cp |rp | linecard slot–id | all} {[high
{0-100}] [low {0-100}]}
Control and Monitoring
High CPU utilization threshold: 1min = 85%, 5min = 80%
Low CPU utilization threshold: 1min = 75%, 5min = 70%
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
NOTE: The 5sec util-threshold cpu command is disabled by default on
all switches. To enable the command, enter util-threshold cpu 5sec
all high {value greater than zero}. To disable the Syslog and traps for the
5sec CPU utilization thresholds, enter util-threshold cpu 5sec all
high 0 or no util-threshold cpu 5sec {cp | rp | linecard
slot-id | all}.
show util-threshold cpu
thresholds.
show util-threshold memory
utilization thresholds.
– Display the configured values of CPU utilization
– Display the configured values of memory
177