Dell Z9500 Reference Manual page 114

Defaults The IP address on the system that is closest to the Telnet address is used in the
outgoing packets.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
8.5.1.0
8.2.1.0
8.1.1.0
7.6.1.0
7.5.1.0
E-Series
Related telnet
Commands
114
• For Loopback interfaces, enter the keyword loopback
then a number from zero (0) to 16383.
• For a port channel interface, enter the keywords port-
channel then a number. The range is from 1 to 512.
• For VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
• For a tunnel interface, enter the keyword tunnel.
Description
Introduced on the S6000-ON.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added support for 4-port 40G line cards on ExaScale.
Increased number of VLANs on ExaScale to 4094 (was
2094).
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Original command
— telnet to another device.
Control and Monitoring