Show Ip Dhcp Snooping - Dell Z9500 Reference Manual

1.1.1.254
Automatic

show ip dhcp snooping

Display the contents of the DHCP binding table or display the interfaces configured with IP Source Guard.
Syntax
show ip dhcp snooping [binding | source-address-validation
[discard-counters [interface interface]]]
Parameters
binding
source-
address-
validation
discard-
counters
interface
interface
Defaults none
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.6(0.0)
Version 9.0.2.0
Version
8.3.19.0
Dynamic Host Configuration Protocol (DHCP)
00:00:00:00:00:20
Display the binding table.
Display the interfaces configured with IP Source Guard.
(OPTIONAL) Display the number of dropped packets.
(OPTIONAL) Specifies an interface to show the discard
counters.
Enter any of the following keywords and slot/port or number
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a port channel interface, enter the keywords port-
channel then a number. The range is from 1 to 512.
EXEC
EXEC Privilege
Added the discard-counters, interface keywords, and
the interface variable.
Introduced on the S6000.
Introduced on the S4820T.
Jan 08 2014 23:57
709