timers bgp
Allows you to adjust the BGP network timers for all neighbors.
Z9500
Syntax
timers bgp keepalive holdtimer
To return to the default values, use the no timers bgp command.
Parameters
keepalive
holdtimer
Defaults
•
•
Command
ROUTER BGP
Modes
Command
Version
History
9.2(1.0)
8.2.1.0
7.4.1.0
Related
neighbor timers
Commands
IPv6 MBGP Commands
Multiprotocol BGP (MBGP) is an enhanced BGP that enables the multicast routing policy throughout the
internet and connecting multicast topologies between BGP and autonomous systems (AS). MBGP is
implemented as per IETF RFC 1858.
show ipv6 mbgproutes
Display the selected IPv6 MBGP route or a summary of all MBGP routes in the table.
Z9500
Syntax
show ipv6 mbgproutes ipv6-address prefix-length | summary
Border Gateway Protocol
Enter the time interval in seconds between which the
software sends keepalive messages. The range is 1 to 65535.
The default is 60 seconds.
Enter the time interval in seconds which the software waits
since the last keepalive message before declaring a BGP peer
dead. The range is 3 to 65535. The default is 180 seconds.
keepalive = 60 seconds
holdtimer = 180 seconds
Description
Introduced on the Z9500.
Introduced on the E-Series ExaScale.
Introduced
– adjusts BGP timers for a specific peer or peer group.
549