Ip Multicast-Limit - Dell Z9500 Reference Manual

Default Disabled
Command EXEC
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.1
Usage To debug the MLD protocol for all ports or for specified ports, use the debug
Information
ipv6 mld_host command. Displayed information includes when a query is
received, when a report is sent, when a mcast joins or leaves a group, and some
reasons why an MLD query is rejected.

ip multicast-limit

To limit the number of multicast entries on the system, use this feature.
Z9500
Syntax
ip multicast-limit [vrf vrf-name] limit
Parameters
vrf vrf-name
limit
Defaults The S-Series default is 4000.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Multicast
• For a VLAN interface, enter the keyword vlan then the
slot/port information.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
(OPTIONAL) Enter the keyword vrf followed by the name of
the VRF to limit the number of multicast on the VRF.
Enter the desired maximum number of multicast entries on
the system. The S-Series range is from 1 to 16000.
1179