Snmp-Server Trap-Source - Dell Z9500 Reference Manual

snmp-server trap-source

Configure a specific interface as the source for SNMP traffic.
Z9500
Syntax
snmp-server trap-source interface
To disable sending traps out a specific interface, use the no snmp trap-source
command.
Parameters
interface
Defaults The IP address assigned to the management interface is the default.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.5.1.0
7.6.1.0
7.5.1.0
Usage To enable this snmp-server trap-source command, configure an IP address
Information on the interface and enable the interface configured as an SNMP trap source.
Related snmp-server community
Commands
Simple Network Management Protocol (SNMP) and Syslog
Enter the following keywords and slot/port or number
information:
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
— sets the community string.
1675