Dell Z9500 Reference Manual page 1390

Parameters
ip-address
slot/port
tunnel
tunnel-id
track
track <obj-id>
ip-protocol-
number
protocol-type
bit
source
mask
any
host ip-address
destination
operator
1390
protocol-type} {source mask | any | host ip-address}
{destination mask | any | host ip-address} [operator]
command.
Enter the IP address of the forwarding router.
Enter the keyword slot / port followed by the slot/port
information.
Enter the keyword tunnel to configure the tunnel setting.
Enter the keyword tunnel-id to redirect the traffic.
Enter the keyword track to enable the tracking.
Enter the keyword track <obj-id> to track object-id.
Enter a number from 0 to 255 for the protocol identified in
the IP protocol header.
Enter one of the following keywords as the protocol type:
• icmp for internet control message protocol
• ip for any internet protocol
• tcp for transmission control protocol
• udp for user datagram protocol
(OPTIONAL) For the TCP protocol type only, enter one or a
combination of the following TCP flags:
• ack = acknowledgement
• fin = finish (no more data from the user)
• psh = push function
• rst = reset the connection
• syn = synchronize sequence number
• urg = urgent field
Enter the IP address of the network or host from which the
packets were sent.
Enter a network mask in /prefix format (/x).
Enter the keyword any to specify that all traffic is subject to
the filter.
Enter the keyword host then the IP address to specify a host
IP address.
Enter the IP address of the network or host to which the
packets are sent.
(OPTIONAL) For TCP and UDP parameters only. Enter one of
the following logical operand:
• eq = equal to
Policy-based Routing (PBR)