Policy-Aggregate - Dell Z9500 Reference Manual

Command CLASS-MAP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.2.1.0
Usage To access this command, enter the class-map command. You can match against
Information only one VLAN ID.
Related class-map
Commands

policy-aggregate

Allow an aggregate method of configuring per-port QoS via policy maps. An aggregate QoS policy is part
of the policy map (input/output) applied on an interface.
Z9500
Syntax
policy-aggregate qos-policy-name
To remove a policy aggregate configuration, use the no policy-aggregate
qos-policy-name command.
Parameters
qos-policy-
name
Defaults none
Command CONFIGURATION (policy-map-input and policy-map-output)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
Quality of Service (QoS)
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced.
— identifies the class map.
Enter the name of the policy map in character format (32
characters maximum).
Description
Introduced on the Z9500.
1455