Dell Z9500 Reference Manual page 1114

Hide thumbs Also See for Z9500:

Table of Contents

port-set port-

address mac-

vlan vlan-id

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Dell# show cam mac linecard 1 port-set 0

(REQUIRED) Enter the keywords port-set then a port-pipe

number to specify the port pipe for which to gather

information. The range of port pipe numbers is from 0 to 3.

(OPTIONAL) Enter the keyword address then a MAC

address in the nn:nn:nn:nn:nn:nn format to display

information on that MAC address.

(OPTIONAL) Enter the keyword dynamic to display only

those MAC addresses the switch dynamically learns.

(OPTIONAL) Enter the keyword interface then the

interface type, slot and port information:

For a Port Channel interface, enter the keywords port-

channel then a number.

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

(OPTIONAL) Enter the keyword static to display only those

MAC addresses specifically configured on the switch.

(OPTIONAL) Enter the keyword vlan then the VLAN ID to

display the MAC address assigned to the VLAN. The range is 1

EXEC Privilege

Introduced on the Z9500.

Introduced on the S4820T.

Added support for 4-port 40G line cards on ExaScale.

Introduced on the S4810.

Introduced on the C-Series.

Introduced on the E-Series.

00:01:02:03:04:09

74:86:7a:ff:6f:1c

00:11:22:33:44:55