Show Mac-Address-Table - Dell Z9500 Reference Manual

1
1
0
1
1

show mac-address-table

Display the MAC address table.
Z9500
Syntax
show mac-address-table [address mac-address | interface
interface | vlan vlan-id] [aging-time] [dynamic | static]
[count [vlan vlan-id] [interface interface-type [slot [/
port]]]]
Parameters
address mac-
address
dynamic
static
aging-time
interface
interface
interface
interface-type
vlan vlan-id
Layer 2
00:01:02:03:04:07
00:01:02:03:04:08
ff:ff:ff:ff:ff:ff
00:01:02:03:04:05
00:01:02:03:04:06
(OPTIONAL) Enter the keyword address then a MAC
address in the nn:nn:nn:nn:nn:nn format to display
information on that MAC address.
(OPTIONAL) Enter the keyword dynamic to display only
those MAC addresses the switch dynamically learns.
Optionally, you can also add one of these combinations:
address/mac-address, interface/interface, or vlan
vlan-id.
(OPTIONAL) Enter the keyword static to display only those
MAC addresses specifically configured on the switch.
Optionally, you can also add one of these combinations:
address/mac-address, interface/interface, or vlan
vlan-id.
Enter the keyword aging-time to display only aging-time
information.
(OPTIONAL) Enter the keyword interface then the
interface type, slot and port information:
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
(OPTIONAL) Instead of entering the keyword interface
then the interface type, slot and port information, as above,
you can enter the interface type, then just a slot number.
(OPTIONAL) Enter the keyword vlan then the VLAN ID to
display the MAC address assigned to the VLAN. The range is 1
to 4094.
DYNAMIC Fo 2/0
DYNAMIC Fo 2/0
STATIC 00001
DYNAMIC Fo 2/0
DYNAMIC Fo 2/0
1115