Tc-Flush-Standard; Vlan Bridge-Priority - Dell Z9500 Reference Manual

tc-flush-standard

Enable the MAC address flushing after receiving every topology change notification.
Z9500
Syntax
tc-flush-standard
To disable, use the no tc-flush-standard command.
Defaults Disabled.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
6.5.1.0
Usage By default, the system implements an optimized flush mechanism for PVST+. This
Information implementation helps in flushing the MAC addresses only when necessary (and less
often) allowing for faster convergence during topology changes. However, if a
standards-based flush mechanism is needed, you can turn this knob command on
to enable flushing MAC addresses after receiving every topology change
notification.

vlan bridge-priority

Set the PVST+ bridge-priority for a VLAN or a set of VLANs.
Z9500
Syntax
vlan vlan-range bridge-priority value
To return to the default value, use the no vlan bridge-priority command.
1426
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced.
Per-VLAN Spanning Tree Plus (PVST+)