Default-Metric - Dell Z9500 Reference Manual

Parameters
always
metric metric-
value
route-map
map-name
Defaults Disabled. Metric: 1.
Command ROUTER RIP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.6.1.0
6.2.1.1
Usage The default route must be present in the switch routing table for the default-
Information information originate command to take effect.

default-metric

Change the default metric for routes. To ensure that all redistributed routes use the same metric value,
use this command with the redistribute command.
Z9500
Syntax
default-metric number
To return the default metric to the original values, use the no default-metric
command.
Parameters
number
1492
(OPTIONAL) Enter the keyword always to enable the switch
software to always advertise the default route.
(OPTIONAL) Enter the keyword metric then a number as
the metric value. The range is from 1 to 16. The default is 1.
(OPTIONAL) Enter the keywords route-map then the name
of a configured route-map.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Specify a number. The range is from 1 to 16. The default is 1.
Routing Information Protocol (RIP)