Snmp-Server Community - Dell Z9500 Reference Manual

IF-MIB::ifAlias.134792448 = STRING:
!----command run on Force10 switch:-----------!
Dell#snmp ifmib ifalias long
!----command run on server connected to switch:------!
> snmpwalk -c public 10.10.10.130 .1.3.6.1.2.1.31 | grep -i
alias | more
IF-MIB::ifAlias.134530304 = STRING: This is a port connected
to Router2. This is a
port connected to Router2. This is a port connected to
Router2. This is a port
connected to Router2. This is a port connected to Router2.
IF-MIB::ifAlias.134792448 = STRING:

snmp-server community

Configure a new community string access for SNMPv1 v2 and v3.
Z9500
Syntax
snmp-server community community-name {ro | rw} [ipv6 ipv6-
access-list-name [ipv6 ipv6-access-list-name | access-list-name
| security-name name] | security-name name [ipv6 ipv6-access-
list-name | access-list-name | security-name name] | access-
list-name [ipv6 ipv6-access-list-name | access-list-name |
security-name name]]]
To remove access to a community, use the no snmp-server community
community-string {ro | rw} [security-name name [access-list-
name | ipv6 access-list-name | access-list-name ipv6 access-
list-name]] command.
Parameters
community-
name
ro
rw
ipv6 access-
list-name
security-name
name
access-list-
name
Defaults none
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
1662
Enter a text string (up to 20 characters long) to act as a
password for SNMP.
Enter the keyword ro to specify read-only permission.
Enter the keyword rw to specify read-write permission.
(Optional) Enter the keyword ipv6 then an IPv6 ACL name (a
string up to 16 characters long).
(Optional) Enter the keywords security-name then the
security name as defined by the community MIB.
(Optional) Enter a standard IPv4 access list name (a string up
to 16 characters long).
Simple Network Management Protocol (SNMP) and Syslog