Seq - Dell Z9500 Reference Manual

Defaults none
Command REDIRECT-LIST
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.5(0.1)
9.4(0.0)
8.4.2.1
8.4.2.0

seq

Configure a filter with an assigned sequence number for the redirect list.
Z9500
Syntax
seq sequence-number {permit | redirect {ip-address | tunnel
tunnel-id}[track <obj-id>] }} {ip-protocol-number | protocol-
type} {source mask | any | host ip-address} {destination mask |
any | host ip-address} [bit] [operator]{source-port source-
port| source-port-range start-port - end-port} {destination-
port destination-port| destination-port-range start-port - end-
port}
To delete a filter, use the no seq sequence-number command.
Parameters
sequence-
number
permit
Policy-based Routing (PBR)
• neq = not equal to
• gt = greater than
• lt = less than
• range = inclusive range of ports (you must specify two
ports for theport command parameter.)
Description
Added the keyword track-id on the Z9500.
Introduced on the Z9500.
Introduced on the S4810, S4820T, S6000, and Z9000.
Introduced on the C-Series.
Introduced on the E-Series TeraScale.
Enter a number from 1 to 65535.
Enter the keyword permit assign the sequence to the
permit list.
1391