Area Stub - Dell Z9500 Reference Manual

Defaults Not configured.
Command ROUTER OSPF
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.6.1.0
7.5.1.0
6.1.1.1
Usage Only the routes within an area are summarized, and that summary is advertised to
Information other areas by the ABR. External routes are not summarized.
Related

area stub

Commands
router ospf
area stub
Configure a stub area, which is an area not connected to other areas.
Z9500
Syntax
area area-id stub [no-summary]
To delete a stub area, use the no area area-id stub command.
Parameters
area-id
no-summary
Defaults Disabled.
Open Shortest Path First (OSPFv2 and OSPFv3)
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added support for the Multi-Process OSPF.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— creates a stub area.
— enters ROUTER OSPF mode to configure an OSPF instance.
Specify the OSPF area in dotted decimal format (A.B.C.D.) or
enter a number from zero (0) to 65535.
(OPTIONAL) Enter the keywords no-summary to prevent the
ABR from sending summary Link State Advertisements (LSAs)
into the stub area.
1219