Ipv6 Multicast Commands; Debug Ipv6 Mld_Host - Dell Z9500 Reference Manual

Version
8.3.11.1
8.3.7.1
Usage Network administrators use static mroutes to control the reach-ability of the
Information multicast sources. If a PIM-registered multicast source is reachable using static
mroute as well as unicast route, the distance of each route is examined and the
route with shorter distance is the one the PIM selects for reach-ability.
Example
Dell#show ip rpf
RPF information for 10.10.10.9

IPv6 Multicast Commands

This section describes the IPv6 multicast commands.

debug ipv6 mld_host

Enable the collection of debug information for MLD host transactions.
Z9500
Syntax
[no] debug ipv6 mld_host [int-count | interface type] [slot/
port-range]
To discontinue collection of debug information for the MLD host transactions, use
the no debug ipv6 mld_host command.
Parameters
int-count
interface type
1178
Description
Introduced on the Z9000.
Introduced on the S4810.
NOTE: The default distance of mroutes is zero (0) and is CLI configurable on a
per route basis.
RPF interface: Gi 3/4
RPF neighbor: 165.87.31.4
RPF route/mask: 10.10.10.9/255.255.255.255
RPF type: unicast
Enter the keyword count to indicate the number of required
debug messages.
Enter the following keywords and slot/port information:
• For a 10G Ethernet interface, enter the keyword
tengigabitethernet then the slot/port information.
• For a 40G interface, enter the keyword fortyGigE then
the slot/port information.
• For a management interface, enter the keyword
managementinterface then the slot/port information.
• For a port-channel interface, enter the keywords port-
channel then the slot/port information.
Multicast