Dell Z9500 Reference Manual page 1392

redirect
ip-address
ip-protocol-
number
tunnel
tunnel-id
track
track <obj-id>
protocol-type
source
mask
any
host ip-address
destination
bit
operator
1392
Enter the keyword redirect to assign the sequence to the
redirect list.
Enter the IP address of the forwarding router.
Enter the keyword ip-protocol-number then the number
from 0 to 255 for the protocol identified in the IP protocol
header.
Enter the keyword tunnel to configure the tunnel setting.
Enter the keyword tunnel-idto redirect the traffic.
Enter the keyword track to enable the tracking.
Enter the keyword track <obj-id> to track object-id.
Enter one of the following keywords as the protocol type:
• icmp for internet control message protocol
• ip for any internet protocol
• tcp for transmission control protocol
• udp for user datagram protocol
Enter the IP address of the network or host from which the
packets were sent.
Enter a network mask in /prefix format (/x).
Enter the keyword any to specify that all traffic is subject to
the filter.
Enter the keyword host then the IP address to specify a host
IP address.
Enter the IP address of the network or host to which the
packets are sent.
(OPTIONAL) For the TCP protocol type only, enter one or a
combination of the following TCP flags:
• ack = acknowledgement
• fin = finish (no more data from the user)
• psh = push function
• rst = reset the connection
• syn = synchronize sequence number
• urg = urgent field
(OPTIONAL) For the TCP and UDP parameters only. Enter
one of the following logical operand:
• eq = equal to
• neq = not equal to
• gt = greater than
Policy-based Routing (PBR)