Related
password
Commands
show running-config
RADIUS Commands
The Dell Networking OS supports the following RADIUS commands.
debug radius
View RADIUS transactions to assist with troubleshooting.
Z9500
Syntax
debug radius
To disable debugging of RADIUS, use the no debug radius command.
Defaults
Disabled.
Command
EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
6.2.1.0
ip radius source-interface
Specify an interface's IP address as the source IP address for RADIUS connections.
Syntax
ip radius source-interface interface
To delete a source interface, use the no ip radius source-interface
command.
Security
— specifies a password for users on terminal lines.
— views the current configuration.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
1583