Show Crypto - Dell Z9500 Reference Manual

Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.5(0.0)
9.4(0.0)
Usage
The source-interface interface attribute is applicable for both the SSH
Information
client as well as the COPY (SCP) commands. Using these attributes the client
session tags an error to the user during run time, in case there is a mismatch
between this command and the ip ssh vrf command.
Example
Dell(conf)#ip ssh source-interface tengigabitethernet 1/42
Dell(conf)#do ssh 10.10.10.2 -l admin
Dell(conf)#no ip ssh source-interface

show crypto

Display the public part of the SSH host-keys.
Z9500
Syntax
show crypto key mypubkey {rsa | rsa1}
Parameters
Key
mypubkey
rsa
rsa1
Defaults none
Command EXEC
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
Security
Description
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S-Series and Z9000.
NOTE: Some of the parameters in this command require licensing to access.
For more information, contact your Dell Networking representative.
Enter the keyword key to display the host public key.
Enter the keyword mypubkey to display the host public key.
Enter the keyword rsa to display the host SSHv2 RSA public
key.
Enter the keyword rsa1 to display the host SSHv1 RSA public
key.
NOTE: If you enable FIPS mode, this parameter is not
available.
1623