Dell Z9500 Reference Manual page 1434

To return to the default setting, use the no service-class dynamic dot1p
command.
Defaults All dot1p traffic is mapped to Queue 0 unless you enable the service-class
dynamic dot1p command. The default mapping is as follows:
dot1p
0
1
2
3
4
5
6
7
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.2.1.0
7.6.1.0
7.5.1.0
6.5.1.0
6.1.1.1
Usage
To honor all incoming 802.1p markings on incoming switched traffic on the
Information
interface, enter this command. By default, this facility is not enabled (that is, the
802.1p markings on incoming traffic are not honored).
1434
INTERFACE
CONFIGURATION
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added the kbps option on the C-Series, E-Series, and S-
Series.
Introduced on the S-Series.
Introduced on the C-Series.
Expanded the command to permit configuration on port
channels.
Introduced on the E-Series.
Queue ID
2
0
1
3
4
5
6
7
Quality of Service (QoS)