Management-Interface; Mode - Dell Z9500 Reference Manual

management-interface

Enable and configure LLDP protocol parameters on the management interface.
Z9500
Syntax
management-interface
To remove LLDP configuration on a management interface, use the no
management-interface command.
Command LLDP (conf-lldp)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
9.2(0.0)
Usage
To enable LLDP on the management interface, use the no disable command in
Information
LLDP-MANAGEMENT-INTERFACE mode (conf-lldp-mgmtIf).

mode

To receive or transmit, set LLDP.
Z9500
Syntax
mode {tx | rx}
To return to the default, use the no mode {tx | rx} command.
Parameters
tx
rx
Defaults Both transmit and receive.
Command CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Link Layer Discovery Protocol (LLDP)
Description
Introduced on the Z9500.
Introduced on the Z9000 and S4810.
Enter the keyword tx to set the mode to transmit.
Enter the keyword rx to set the mode to receive.
1149