Ip Redirect-List - Dell Z9500 Reference Manual

group is applied to an interface and the next-hop is reachable, the rules are added
into the PBR CAM region. When incoming traffic hits an entry in the CAM, the
traffic is redirected to the corresponding next-hop IP address specified in the rule.
Related
•
Commands
•

ip redirect-list

Configure a redirect list and enter REDIRECT-LIST mode.
Z9500
Syntax
ip redirect-list redirect-list-name
To remove a redirect list, use the no ip redirect-list command.
Parameters
redirect-list-
name
Defaults none
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.5(0.1)
9.4(0.0)
8.4.2.1
8.4.2.0
6.5.3.0
Policy-based Routing (PBR)
NOTE: Apply the redirect list to physical, VLAN, or LAG interfaces only.
show cam pbr – displays the content of the PBR CAM.
show ip redirect-list – displays the redirect-list configuration.
Enter the name of a redirect list.
Description
Introduced on the Z9500.
Introduced on the S4810, S4820T, S6000, and Z9000.
Introduced on the C-Series and S-Series.
Introduced on the E-Series TeraScale.
Introduced on the E-Series ExaScale.
1387