Ipv6 Ospf Bfd All-Neighbors - Dell Z9500 Reference Manual

ipv6 ospf bfd all-neighbors

Establish BFD sessions with all OSPFv3 neighbors on a single interface or use non-default BFD session
parameters.
Z9500
Syntax
ipv6 ospf bfd all-neighbors [disable | [interval interval
min_rx min_rx multiplier value role {active | passive}]]
To disable all BFD sessions on an OSPFv3 interface implicitly, use the no ipv6
ospf bfd all-neighbors disable command in interface mode..
Parameters
disable
interval
milliseconds
min_rx
milliseconds
multiplier value
role [active |
passive]
Defaults See Parameters
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
Open Shortest Path First (OSPFv2 and OSPFv3)
(OPTIONAL) Enter the keyword disable to disable BFD on
this interface.
(OPTIONAL) Enter the keyword interval to specify non-
default BFD session parameters beginning with the
transmission interval. The range is from 50 to 1000. The
default is 100.
Enter the keywords min_rx to specify the minimum rate at
which the local system receives control packets from the
remote system. The range is from 50 to 100. The default is
100.
Enter the keyword multiplier to specify the number of
packets that must be missed in order to declare a session
down. The range is from 3 to 50. The default is 3.
Enter the role that the local system assumes:
• Active — The active system initiates the BFD session.
Both systems can be active for the same session.
• Passive — The passive system does not initiate a
session. It only responds to a request for session
initialization from the active system.
The default is Active.
Description
Introduced on the Z9500.
1309