Snmp-Server Contact - Dell Z9500 Reference Manual

Example
Dell(conf)# ip access-list standard snmp-ro-acl
Dell(config-std-nacl)#seq 5 permit host 10.10.10.224
Dell(config-std-nacl)#seq 10 deny any count
!
Dell(conf)#snmp-server community guest ro snmp-ro-acl
Dell(conf)#
Related
ip access-list standard
Commands
IP address.
ipv6 access-list
show running-config

snmp-server contact

Configure contact information for troubleshooting this SNMP node.
Z9500
Syntax
snmp-server contact text
To delete the SNMP server contact information, use the no snmp-server
contact command.
Parameters
text
Defaults none
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
1664
— names (or selects) a standard access list to filter based on
— configures an access list based on IPv6 addresses or protocols.
— displays the current SNMP configuration and defaults.
Enter an alphanumeric text string, up to 55 characters long.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Simple Network Management Protocol (SNMP) and Syslog