Dell Z9500 Reference Manual page 1672

Hide thumbs Also See for Z9500:

Table of Contents

CONFIGURATION

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

In order to configure the router to send SNMP notifications, enter at least one

snmp-server host command. If you enter the command with no keywords, all

trap types are enabled for the host. If you do not enter an snmp-server host

command, no notifications are sent.

In order to enable multiple hosts, issue a separate snmp-server host command

for each host. You can specify multiple notification types in the command for each

When multiple snmp-server host commands are given for the same host and

type of notification (trap or inform), each succeeding command overwrites the

previous command. Only the last snmp-server host command will be in effect.

For example, if you enter an snmp-server host inform command for a host

and then enter another snmp-server host inform command for the same

host, the second command replaces the first command.

The snmp-server host command is used with the snmp-server enable

command. Use the snmp-server enable command to specify which SNMP

notifications are sent globally. For a host to receive most notifications, at least one

snmp-server enable command and the snmp-server host command for that

host must be enabled.

Introduced on the Z9500.

Added support for config and ecmp traps.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

Added support for VRRP traps.

Added support for STP and xSTP notification types.

Introduced on the S-Series.

Introduced on the C-Series.

Simple Network Management Protocol (SNMP) and Syslog