Per-Vlan Spanning Tree Plus (Pvst+); Description - Dell Z9500 Reference Manual

Per-VLAN Spanning Tree Plus (PVST+)

The Dell Networking operating software implementation of per-VLAN spanning tree plus (PVST+) is based
on the IEEE 802.1w standard spanning tree protocol.
NOTE: For easier command line entry, the plus (+) sign is not used at the command line.

description

Enter a description of the PVST+.
Z9500
Syntax
description {description}
To remove the description, use the no description {description}
command.
Parameters
description
Defaults none
Command SPANNING TREE PVST+ (The prompt is "config-pvst".)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.7.1.1
Per-VLAN Spanning Tree Plus (PVST+)
Enter a description to identify the spanning tree (80
characters maximum).
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced.
42
1415