Ip Ssh Rsa-Authentication (Config) - Dell Z9500 Reference Manual

Hide thumbs Also See for Z9500:

Table of Contents

Dell(conf)# ip ssh rhostsfile flash://shosts

This command specifies the rhost file used for host-based authentication. This

creates/ file overwrites the flash:/ADMIN_DIR/ssh/shosts file and deletes

the user-specified file. Even though this command is a global configuration

command, it does not appear in the running configuration because you only need

to run this command once.

This file contains hostnames and usernames, for which hosts and users, rhost-

authentication can be allowed.

ip ssh rsa-authentication (Config)

Enable RSA authentication for the SSHv2 server.

ip ssh rsa-authentication enable

To disable RSA authentication, use the no ip ssh rsa-authentication

enable command.

CONFIGURATION

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Introduced on the S-Series.

Introduced on the C-Series.

Introduced on the E-Series.

NOTE: For rhostfile and pub-key-file, the administrator must FTP the

file to the switch.

Enter the keyword enable to enable RSA authentication for

the SSHv2 server.

Introduced on the Z9500.

Introduced on the S4820T.